Both utility · same Case IH lineup
Case IH Farmall 90C vs Case IH Farmall 100C
| Spec | Case IH Farmall 90C | Case IH Farmall 100C |
|---|---|---|
| Price | not published | not published |
| What that price is | no published price | no published price |
| Size class | Utility | Utility |
| Transmission | Power Shuttle | Power Shuttle |
| Engine hp | 90 hp | 101 hp |
| PTO hp | 73 hp | 85 hp |
| Loader lift | 4,625 lbsmeasuring point not recorded | 4,625 lbsmeasuring point not recorded |
| Three-point lift | 4,123 lbs24 in behind the lift points | 4,123 lbs24 in behind the lift points |
| Hydraulic flow | 21.7 GPM | 21.7 GPM |
| Drive | MFWD | MFWD |
| Engine | FPT | FPT |
| Weight | 10,240 lbs | 10,240 lbs |
| Fuel tank | 34.3 gal | 34.3 gal |
| 4WD | Yes | Yes |
| Front loader | Yes | Yes |
| Cab available | Yes | Yes |
| Hydrostatic | No | No |
| Power steering | Yes | Yes |
| Cruise control | No | No |
| Warranty | not published | not published |
A highlighted cell wins its row on the rule named above the table: more power, lift, capacity or flow, or a lower price. A lift row is left unwon whenever the two makers measured in different places, or where either of them did not say — a figure quoted at the pivot pin and one quoted 500 mm ahead of it describe the same loader and differ by roughly a third, so ranking them against each other would invent a result. Prices are typical list and move with dealer packages.
From owner discussion and long-term write-ups
What owners of each one say
Case IH Farmall 90C
What they like
- 21.7 gpm of implement flow, 4.8 gpm more than the 90A beside it and the highest in the medium utility line under 105 hp
- Electronic draft control with lower-link sensing rather than the mechanical top-link sensing the A-series tractors use
- 4,123 lb of hitch lift as standard and 6,938 lb with the optional auxiliary ram - the biggest optional lift in the class
- Class 1.5 heavy-duty MFD front axle with limited slip, a step up from the Class 1.0 axle on the 90A and 100A
- The L635 loader lifts 4,625 lb to 149 in., with non-self-levelling or mechanical self-levelling offered
- 34.3 gal of fuel and 540/540E/1000 PTO speeds as standard
What they complain about
- Case IH publishes no list price and its Build & Price tool hands you to a dealer rather than a figure, so this page cannot tell you what it costs - every public number found either bundles the loader or is a financing offer
- One transmission only - the 24 x 24 Hi-Lo, with no option listed, so anyone who wants a simple 12 x 12 power shuttle has to buy the 90A instead
- Stage V means SCR and a 3.4 gal DEF tank, where the small utility C tractors below it need no DEF at all
- 10,240 lb bare is heavier than the 101 hp Farmall 100A and 1,422 lb over the 90A, so it compacts more and needs more tractor to move
- Case IH's own model page leaves the PTO horsepower blank; the 73 hp figure comes from the utility brochure
- The L635's 4,625 lb is published without a measuring point, so it cannot be set beside a pivot-pin figure
- No warranty term is stated in the brochure or on the model page
Case IH Farmall 100C
What they like
- 85 PTO hp from 101 gross is an 84 percent driveline figure, enough for a mid-size round baler or a 10-foot mower conditioner
- 12 x 12 electronic power shuttle standard, with a 20 x 20 creeper build optional - a more conventional choice than the 90C's Hi-Lo-only transmission
- 21.7 gpm of implement flow, 4.8 gpm more than the 100A of the same power
- 4,123 lb of hitch lift standard, rising to 6,938 lb with the optional auxiliary ram
- Class 1.5 heavy-duty MFD front axle with limited slip, and up to three rear remotes with a diverter
- 540/540E/1000 PTO speeds and 34.3 gal of fuel as standard
What they complain about
- Case IH publishes no list price and its Build & Price tool hands you to a dealer rather than a figure, so this page cannot tell you what it costs - every public number found either bundles the loader or is a financing offer
- Stage V brings SCR and a 3.4 gal DEF tank to fill alongside the diesel
- 10,240 lb bare, 1,422 lb heavier than the equally powerful Farmall 100A, which is weight you pay for in fuel and ground pressure
- Case IH's own model page says 101 hp where the previous-generation utility C brochure rated this model 99 - the figure used here is the current one
- Cab-only, with no ROPS build to bring the price down
- The L635's 4,625 lb has no published measuring point, and no warranty term is stated anywhere in the maker's material