Utility against Sub-Compact · same Case IH lineup

Case IH Farmall 100C vs Case IH Farmall 25SC

Case IHFarmall 100C

Case IH

Case IH Farmall 100C

Ask a dealer

101 hp engine · 85 PTO−16% to the shaft
Case IHFarmall 25SC

Case IH

Case IH Farmall 25SC

Ask a dealer

24.7 hp engine · 17.2 PTO−30% to the shaft

The Case IH Farmall 100C carries 85 hp to the PTO against 17.2; the Case IH Farmall 100C lifts 4,625 lbs on the loader against 693.

Case IH Farmall 100C and Case IH Farmall 25SC compared row by row. A highlighted cell takes that row on the stated rule: more power, lift, capacity or flow, or a lower price.
SpecCase IH Farmall 100CCase IH Farmall 25SC
Pricenot publishednot published
What that price isno published priceno published price
Size classUtilitySub-Compact
TransmissionPower ShuttleHydrostatic
Engine hp101 hp24.7 hp
PTO hp85 hp17.2 hp
Loader lift4,625 lbsmeasuring point not recorded693 lbsmeasuring point not recorded
Three-point lift4,123 lbs24 in behind the lift points728 lbs24 in behind the lift points
Hydraulic flow21.7 GPM4.6 GPM
DriveMFWDMFWD
EngineFPTnot published
Weight10,240 lbs1,444 lbs
Fuel tank34.3 gal6.6 gal
4WDYesYes
Front loaderYesYes
Cab availableYesNo
HydrostaticNoYes
Power steeringYesYes
Cruise controlNoNo
Warrantynot publishednot published

A highlighted cell wins its row on the rule named above the table: more power, lift, capacity or flow, or a lower price. A lift row is left unwon whenever the two makers measured in different places, or where either of them did not say — a figure quoted at the pivot pin and one quoted 500 mm ahead of it describe the same loader and differ by roughly a third, so ranking them against each other would invent a result. Prices are typical list and move with dealer packages.

From owner discussion and long-term write-ups

What owners of each one say

Case IH Farmall 100C

What they like

  • 85 PTO hp from 101 gross is an 84 percent driveline figure, enough for a mid-size round baler or a 10-foot mower conditioner
  • 12 x 12 electronic power shuttle standard, with a 20 x 20 creeper build optional - a more conventional choice than the 90C's Hi-Lo-only transmission
  • 21.7 gpm of implement flow, 4.8 gpm more than the 100A of the same power
  • 4,123 lb of hitch lift standard, rising to 6,938 lb with the optional auxiliary ram
  • Class 1.5 heavy-duty MFD front axle with limited slip, and up to three rear remotes with a diverter
  • 540/540E/1000 PTO speeds and 34.3 gal of fuel as standard

What they complain about

  • Case IH publishes no list price and its Build & Price tool hands you to a dealer rather than a figure, so this page cannot tell you what it costs - every public number found either bundles the loader or is a financing offer
  • Stage V brings SCR and a 3.4 gal DEF tank to fill alongside the diesel
  • 10,240 lb bare, 1,422 lb heavier than the equally powerful Farmall 100A, which is weight you pay for in fuel and ground pressure
  • Case IH's own model page says 101 hp where the previous-generation utility C brochure rated this model 99 - the figure used here is the current one
  • Cab-only, with no ROPS build to bring the price down
  • The L635's 4,625 lb has no published measuring point, and no warranty term is stated anywhere in the maker's material

Case IH Farmall 25SC

What they like

  • 540 rear PTO plus a 2,500 rpm mid-PTO as standard equipment, so a belly mower and a rear implement are both live without an add-on kit
  • Independent electrohydraulic MFD engagement rather than a mechanical lever, which is unusual kit at this size
  • 728 lb of Category I hitch lift measured 24 in. behind the pin, which is solid for a 1,444 lb tractor
  • Inboard-planetary-free simplicity: an indirect-injection 1.26 L three with no DEF tank and no urea to manage
  • At 1,444 lb bare it is light enough to cross a lawn without rutting it, and short enough at 97 in. to turn inside a suburban garden

What they complain about

  • Case IH publishes no list price and its Build & Price tool hands you to a dealer rather than a figure, so this page cannot tell you what it costs - every public number found either bundles the loader or is a financing offer
  • 4.6 gpm of implement flow is the lowest in this catalog's subcompact class, so loader and backhoe cycles are slow
  • The L320S loader lifts 693 lb to a 72 in. maximum height, which is below what a Kubota BX or a Deere 1025R loader will put over a truck side
  • Case IH does not state where the 693 lb was measured, so it cannot be set beside the pivot-pin ratings other makers publish
  • Zero rear remotes in the base build; the first is an option
  • No warranty term is printed on the model page or the spec sheet - the 6-year extended cover Case IH advertises is written for the compact A and C series, not the subcompact
  • Only one transmission is offered, so there is no gear build for anyone who does not want a hydrostat