Both utility · LS Tractor against Kubota

LS MT352 vs Kubota M6060

LS MT352

LS Tractor

LS MT352

~$42,500

52 hp engine · 44.2 PTO−15% to the shaft
Kubota M6060

Kubota

Kubota M6060

~$43,018

66.4 hp engine · 56 PTO−16% to the shaft

The LS MT352 lists about $518 lower; the Kubota M6060 carries 56 hp to the PTO against 44.2; the Kubota M6060 lifts 2,469 lbs on the loader against 2,396; the Kubota M6060 buys more PTO horsepower per dollar, 1.3 per $1,000 against 1.04.

LS MT352 and Kubota M6060 compared row by row. A highlighted cell takes that row on the stated rule: more power, lift, capacity or flow, or a lower price.
SpecLS MT352Kubota M6060
Price~$42,500~$43,018
What that price isdealer list, not MSRPMSRP, base build
Size classUtilityUtility
TransmissionHydrostaticPower Shuttle
Engine hp52 hp66.4 hp
PTO hp44.2 hp56 hp
Loader lift2,396 lbsmeasuring point not recorded2,469 lbsat the pivot pin
Three-point lift2,755 lbsat the ball ends3,307 lbs24 in behind the lift points
Hydraulic flow13.7 GPM11.0 GPM
Drive4WD4WD
EngineLSKubota
Weight3,935 lbs5,005 lbs
Fuel tank10.6 gal18.5 gal
4WDYesYes
Front loaderYesYes
Cab availableYesYes
HydrostaticYesNo
Power steeringYesYes
Cruise controlNoNo
Warranty6 yr powertrain3 yr / 3000 hr powertrain

A highlighted cell wins its row on the rule named above the table: more power, lift, capacity or flow, or a lower price. A lift row is left unwon whenever the two makers measured in different places, or where either of them did not say — a figure quoted at the pivot pin and one quoted 500 mm ahead of it describe the same loader and differ by roughly a third, so ranking them against each other would invent a result. Prices are typical list and move with dealer packages.

From owner discussion and long-term write-ups

What owners of each one say

LS MT352

What they like

  • 2,755 lb Category 2 3-point lift is over half again what the MT2 frame offers, which is the real reason to move up a series
  • Turbocharged common-rail L3C19-T pulls 52 hp from only 114.7 cu in, so it stays a physically small three-cylinder
  • Three transmissions are offered at this one hp point - 16x16 synchro shuttle, hydrostatic, and the PCT power shuttle - rather than one fixed choice
  • 13.7 GPM on the hydrostatic build, rising to 15.0 GPM on the cab version, against a flat 11.7 across the whole MT2 range
  • Factory cab available, and the two dealers consulted agreed on the open-station price to within about $500

What they complain about

  • LS publishes no price for it, so the figure comes from dealer books; the cab version runs roughly $7,000 more again
  • 2,396 lb of loader lift is actually lower than the 2,506 lb the much cheaper MT242 carries, because the MT3 loader is matched to a taller frame rather than a heavier one
  • The 10.6-gallon tank is carried straight over from the MT2 frame and is small for 52 hp - the cab build gets 12.4
  • LS does not publish a loader measuring point on this or any model page, so the 2,396 lb rating is not comparable against a pivot-pin figure
  • Naming is a maze: MT352H, MT352HC, MT352C and MT352PCT are all the same tractor with different transmissions and cabs
  • Weight is quoted as a 3,935 to 4,446 lb range across builds rather than per configuration

Kubota M6060

What they like

  • The V3307 gives 56 PTO hp, six more than the M5660SU, for $8,925 more
  • Factory cab is offered, which the M5660SU cannot be ordered with at any price
  • Full-flat deck on cab models and tilt steering standard, both absent from the SU below it
  • Same 3,307 lb hitch capacity and LA1154 loader as the M7060 above it, so the step up in engine does not change what it can pick up
  • 5,005 lb in 4WD ROPS form is 618 lb more than the M5660SU, which is useful ballast for loader work
  • 18.5 gal in ROPS form rises to 23.8 gal when the cab is fitted

What they complain about

  • 11.0 gpm to the hitch is barely above the M5660SU's 10.6, so the bigger engine does not speed the hydraulics up
  • Only the M7060 offers the 12-speed box, so the M6060 is stuck with F8/R8
  • One standard remote valve, with the second, third and flow control all chargeable options
  • At $43,018 it costs more than a 63.4 hp MX6000 and a 60 hp L6070, both of which carry more modern cab and operator kit