Both sub-compact · same TYM lineup
TYM T264 vs TYM 2400
| Spec | TYM T264 | TYM 2400 |
|---|---|---|
| Price | not published | not published |
| What that price is | no published price | no published price |
| Size class | Sub-Compact | Sub-Compact |
| Transmission | Hydrostatic | Gear |
| Engine hp | 24 hp | 24 hp |
| PTO hp | 18.3 hp | 21 hp |
| Loader lift | 1,380 lbsat the pivot pin | 1,314 lbsat the pivot pin |
| Three-point lift | 1,534 lbsat the ball ends | 1,499 lbsat the ball ends |
| Hydraulic flow | 4.4 GPM | 4.7 GPM |
| Drive | 4WD | 4WD |
| Engine | TYM | TYM |
| Weight | 1,881 lbs | 1,792 lbs |
| Fuel tank | 6.6 gal | 6.0 gal |
| 4WD | Yes | Yes |
| Front loader | Yes | Yes |
| Cab available | No | No |
| Hydrostatic | Yes | No |
| Power steering | Yes | Yes |
| Cruise control | Yes | Yes |
| Warranty | 6 yr / 3000 hr powertrain | 6 yr / 3000 hr powertrain |
A highlighted cell wins its row on the rule named above the table: more power, lift, capacity or flow, or a lower price. A lift row is left unwon whenever the two makers measured in different places, or where either of them did not say — a figure quoted at the pivot pin and one quoted 500 mm ahead of it describe the same loader and differ by roughly a third, so ranking them against each other would invent a result. Prices are typical list and move with dealer packages.
From owner discussion and long-term write-ups
What owners of each one say
TYM T264
What they like
- 1,534 lb of hitch lift at the link ends is the most in TYM's sub-compact line and more than a Kubota BX or a Deere 1025R will manage
- Cruise control as standard on a sub-compact, which matters on a long mow
- 24 hp at 2,800 rpm rather than 3,000-3,200, so it is doing less work per horsepower and running quieter
- Dual gear pump splits 4.4 gpm to the implement circuit and 2.7 gpm to steering, so a loader cycle does not drag on the wheel
- Infinite 2-range HST reaching 12.9 mph, half as fast again as the T224
- Powertrain cover of 72 months or 3,000 hours for non-commercial use
What they complain about
- TYM publishes no price - every model page ends at Request a Quote, and no two independent dealers quote a bare tractor, so the figure here would have to be invented
- Only one remote valve, and it is optional
- 4.4 gpm of implement flow is modest for a tractor asked to run a loader and a mid-mount deck
- The TX2000 loader lifts 1,380 lb at the pivot point, which TYM publishes in kilograms-force on the loader page and not at all on the tractor page
- 1,881 lb is heavy for a sub-compact if the job is crossing a soft lawn
- The hitch lift falls to 1,102 lb measured 24 in. behind the link ends, so a long implement loses nearly a third of the figure
TYM 2400
What they like
- 21 PTO hp out of 24 gross on the constant-mesh build, an 88 percent driveline figure that the hydrostatic version cannot approach
- 540 and 1,000 rpm rear PTO speeds, which is unusual on a sub-compact and useful for implements built for the faster shaft
- Dual gear pump with 4.7 gpm to the implement circuit, the highest implement flow in TYM's sub-compact range
- Two optional remote valves rather than one
- Cruise control is offered on the HST build for anyone who wants the hydrostat instead
- 72-month, 3,000-hour powertrain cover for non-commercial use
What they complain about
- TYM publishes no price - every model page ends at Request a Quote, and no two independent dealers quote a bare tractor, so the figure here would have to be invented
- Six forward gears and only two reverse, so loader work means hunting for a usable reverse ratio - this is a gearbox for mowing, not for shuttling
- Choosing the 2400H hydrostatic costs 3 PTO hp, taking 21 down to 18
- 6.0 gal is the smallest fuel tank in the TYM line
- The BL100S loader lifts 1,314 lb at the pivot point, below what the T264 beside it manages
- Hitch lift drops from 1,499 lb at the link ends to 974 lb at 24 in. behind them